At Jason’s House, press Triangle at the lumber pile, then replace the damaged stair boards and nail each replacement down until the staircase is repaired.
The damaged wooden staircase stands outside a stilt house, with Jason’s House identified by the location banner at the bottom left of your HUD. Grand Theft Auto VI is listed for PlayStation 5 and Xbox Series X|S. This guide covers starting the repair, removing the damaged treads, and fastening their replacements.

How to fix the steps at Jason’s House in Grand Theft Auto VI
Approach the lumber pile
Walk over to the stack of planks beside the outside staircase. An interaction prompt appears beside the materials.

Start repairing the stairs
Press Triangle at the lumber stack to collect materials and begin the stair repair sequence.
Remove the broken stair board
Pull off the damaged tread. Your character then takes a fresh plank from the stack and positions it on the bottom stair.

Nail down the replacement
At the NAIL R2 prompt, press R2 repeatedly to fire the nail gun, driving nails into both sides of the replacement plank.

Repair the upper steps
After fastening the bottom board, your character checks it with his foot, collects another plank, and moves higher. Remove the upper damaged board, which your character throws over the railing, then secure its replacement with several nail gun shots. Continue to the next section, remove the loose board, and fasten another replacement. Repeat the removal and fastening cycle until the entire flight is repaired; your character then walks up the staircase.

Look to the bottom-right corner for the fastening prompt when securing a replacement board.
Related Grand Theft Auto VI guides







Leave a Reply